REMOVE ALL NECESSARY COMPONENTS IN THE FRONT SUSPENSION. REMOVE AND REPLACE FRONT STRUTS ASSEMBLY INCLUDING THE STRUT MOUNTS, BEARING, AND STRUT BELLOWS WITH THE BUSHING. ASSEMBLE BACK TOGETHER AND MAKE ALL NECESSARY ADJUSTMENTS. TEST ALL AFFECTED AREAS.
4- WHEEL ALIGNMENT
HAUCHEE C. gave our service a 5 star review on 6/19/2023
Connected a scan tool and found code P26CB – Electric Coolant Pump Communication. Performed an inspection of the engine cooling system and found no faults. Used the scan tool to command the engine water pump on and found the pump was inoperative. With the key on, engine off, used a multi-meter to check for the presence of voltage and ground at the engine water pump and found both were present. Used a set of fused jumper wires to apply voltage and ground to the engine water pump and found the engine water pump was inoperative.
DRAIN COOLING SYSTEM. REMOVE ALL NECESSARY COMPONENTS. REMOVE AND REPLACE WATER PUMP AND THERMOSTAT. ASSEMBLE TOGETHER AND MAKE ALL NECESSARY ADJUSTMENTS.
AMANDA G. gave our service a 5 star review on 4/14/2023
Confirmed the customer's complaint and found the engine did not start intermittently. Performed a visual inspection of the battery and battery terminals, but found no faults. Used a multi-meter to measure the voltage across the battery terminals and found the measured voltage was below the specified range of 12.4 – 12.6 Volts. Connected a battery charger and charged the battery until the voltage returned to the specified 12.6 Volts. Used a battery conductance tester to test the battery and found the battery was unable to conduct the specified amount of current, which verified it was defective.
BATTERY SERVICE: CLEAN CORRODED BATTERY. REMOVE AND REPLACE BATTERY. MAKE SURE ALL WIRES ARE INSERTED INTO PROPER CAVITIES. RE-ASSEMBLE BACK TOGETHER. CONNECT BATTERY. MAKE SURE ALL OTHER WIRES ARE HARNESSED PROPERLY. TEST ALL AFFECTED SYSTEM.
CALIFORNIA BATTERY FEE
JULIANNA J. gave our service a 5 star review on 3/10/2023
CLEAN CORRODED BATTERY. REMOVE AND REPLACE BATTERY AND POSITIVE TERMINAL BATTERY CLAMP. MAKE SURE ALL WIRES ARE INSERTED INTO PROPER CAVITIES. RE-ASSEMBLE BACK TOGETHER. CONNECT BATTERY. MAKE SURE ALL OTHER WIRES ARE HARNESSED PROPERLY. TEST ALL AFFECTED SYSTEM.