CRM Mitchell1

Home / Archives for CRM Mitchell1 / Page 6

We Service and Repair all CRM Mitchell1 cars

  • 2016 Land Rover Range Rover Evoque

    Land Rover Range Rover Evoque
    Mileage
    45,009
    Service Date
    9/28/2023
    Services Performed
    • VEHICLE SERVICE: – CHANGE ENGINE OIL AND FILTER – REPLACE ENGINE AIR FILTER – TIRE INFLATION CHECK – BRAKE COMPONENT INSPECTION – ALL FLUID LEVEL CHECK – RESET MAINTENCE COUNTER
     
    KIM L. gave our service a 5 star review on 9/29/2023
  • 2014 Ford Fiesta

    Ford Fiesta
    Mileage
    93,902
    Service Date
    9/28/2023
    Services Performed
    • Confirmed the customer's complaint and found the engine did not start. Inspected the ignition system and the air intake system, but found no concerns. Inspected the engine coolant level and condition and found the engine coolant level was low. Filled the engine coolant to the proper operating level and continued diagnosing the vehicle. Connected an engine coolant pressure tester to the radiator and pressurized the engine cooling system to check for leaks. Inspected the engine cooling system and did not find a leak, but the engine coolant pressure tester reading indicated a leak was present. Removed the engine coolant pressure tester from the radiator, used a gas analyzer to check for the presence of hydrocarbons at the radiator filler neck and found hydrocarbons were present. Removed the spark plugs for inspection and found the spark plugs were contaminated with engine coolant. Rand a compression test and there was no compression in the cylinders. Internal problem with this engine. Will need to have cylinder head gasket replaced or possibly the engine.
    • DRAIN ALL FLUIDS. REMOVE ALL NECESSARY COMPONENTS INT HE ENGINE BAY. REMOVE CYLINDER HEAD AND SEND TO THE MACHINE SHOP. ASSEMBLE CYLINDER HEAD BACK AND INSTALL CYLINDER HEAD GASKET SET, OIL PUMP DRIVE BELT, TIMING BELT, HOSE, PLASTIC ELBOW, THERMOSTAT HOUSING WITH THERMOSTAT. ASSEMBLE TOGETHER AND MAKE ALL NECESSARY ADJUSTMENTS. ADD ALL FLUIDS. TEST ALL AFFECTED AREAS.
    • MACHINE SHOP
     
    MICAH R. gave our service a 5 star review on 9/28/2023
  • 2013 Lexus RX 350

    Lexus RX 350
    Mileage
    31,664
    Service Date
    9/25/2023
    Services Performed
    • VEHICLE SERVICE: – CHANGE ENGINE OIL AND FILTER – TIRE INFLATION CHECK – BRAKE COMPONENT INSPECTION – ALL FLUID LEVEL CHECK – RESET MAINTENCE COUNTER
     
    MAYA P. gave our service a 5 star review on 9/26/2023
  • 2015 Lexus IS 250

    Lexus IS 250
    Mileage
    78,587
    Service Date
    9/22/2023
    Services Performed
    • VEHICLE SERVICE: – CHANGE ENGINE OIL AND FILTER – TIRE INFLATION CHECK – BRAKE COMPONENT INSPECTION – ALL FLUID LEVEL CHECK – RESET MAINTENCE COUNTER
    • REMOVE AND REPLACE FRONT WIPER BLADES
     
    Kathleen S. gave our service a 5 star review on 9/23/2023
  • 2019 Toyota Corolla

    Toyota Corolla
    Mileage
    138,052
    Service Date
    9/22/2023
    Services Performed
    • REMOVE ALL NECESSARY COMPONENTS. REMOVE ALL TORN BELT COMPONENTS. INSTALL NEW DRIVE BELT. ASSEMBLE TOGETHER AND MAKE ALL NECESSARY ADJUSTMENTS. TEST ALL AFFECTED AREAS.
     
    LUPE D. gave our service a 5 star review on 9/22/2023
  • 2013 Jeep Grand Cherokee

    Jeep Grand Cherokee
    Mileage
    93,232
    Service Date
    9/13/2023
    Services Performed
    • VEHICLE SERVICE: – CHANGE ENGINE OIL AND FILTER – REPLACE ENGINE AIR FILTER – TIRE INFLATION CHECK – BRAKE COMPONENT INSPECTION – ALL FLUID LEVEL CHECK – RESET MAINTENCE COUNTER
    • Connected a scan tool and found code P0522 – Engine Oil Pressure Sensor/Switch Low. Performed an inspection of the engine oil level and condition and found it was at the proper level and clean. Performed a visual inspection of the engine oil pressure sensor wiring harness and found evidence of engine oil on the wiring harness was present. Disconnected the engine oil pressure sensor wiring harness connector, visually inspected the connector and terminals and found evidence of engine oil. Further inspection of the engine oil pressure sensor showed sign of engine oil inside the engine oil pressure sensor connector. Key on, used a fused jumper wire and tapped ground at the engine oil pressure sensor sense circuit in the engine oil pressure sensor harness connector and observed the oil pressure indicator changed, which indicated no circuit faults were present. Removed the engine oil pressure sensor, installed an oil pressure gauge, started the engine and performed an oil pressure test. Found the measured engine oil pressure was within the manufacturer’s specification. The results of these tests verified the engine oil pressure sensor was faulty. REMOVE AND REPLACE OIL PRESSURE SENSOR. ASSEMBLE TOGETHER AND MAKE ALL NECESSARY ADJUSTMENTS. TEST ALL AFFECTED AREAS.
     
    MARIA O. gave our service a 5 star review on 9/19/2023
  • 2005 Kia Sorento

    Kia Sorento
    Mileage
    205,803
    Service Date
    9/12/2023
    Services Performed
    • Confirmed the customer's complaint and found the engine idled fast. Inspected the air intake system for signs of leaks and found no obvious faults. Connected a smoke machine to the air intake system, induced smoke into the system to check for leaks, and found smoke leaked from the intake manifold gasket. Removed the intake manifold and found the intake manifold gasket was damaged. The results of these tests verified the intake manifold gasket was faulty.
    • REMOVE ALL NECESSARY COMPONENTS. REMOVE INTAKE MANIFOLD. REMOVE AND REPLACE INTAKE MANIFOLD GASKET. ASSEMBLE TOGETHER AND MAKE ALL NECESSARY ADJUSTMENTS. TEST ALL AFFECTED AREAS.
     
    CARLOS L. gave our service a 5 star review on 9/12/2023
  • 2012 Chevrolet Colorado

    Chevrolet Colorado
    Mileage
    123,103
    Service Date
    9/11/2023
    Services Performed
    • VEHICLE SERVICE: – CHANGE ENGINE OIL AND FILTER – TIRE INFLATION CHECK – BRAKE COMPONENT INSPECTION – ALL FLUID LEVEL CHECK – RESET MAINTENCE COUNTER
    • REMOVE FRONT BRAKE ROTORS REPLACE FRONT BRAKE PADS REPLACE FRONT BRAKE ROTORS ASSEMBLE BACK TOGETHER
     
    GREG M. gave our service a 5 star review on 9/12/2023
  • 2014 Chrysler 300

    Chrysler 300
    Mileage
    110,350
    Service Date
    8/22/2023
    Services Performed
    • FASTEN COVER BACK IN PROPER PLACE. INSTALL BIGGER WASHER TO KEEP IT IN PLACE.
     
    MATT M. gave our service a 5 star review on 8/22/2023
  • 2008 Mercedes-Benz C300

    Mercedes-Benz C300
    Mileage
    56,293
    Service Date
    8/22/2023
    Services Performed
    • REMOVE AND REPLACE RIGHT AND LEFT FUEL PUMP ASSEMBLY. ASSEMBLE TOGETHER AND MAKE ALL NECESSARY ADJUSTMENTS. TEST ALL AFFECTED AREAS.
    • REMOVE ALL NECESSARY COMPONENTS FROM THE ENGINE COMPARTMENT. REMOVE AND REPLACE ALL FUEL INJECTORS. ASSEMBLE TOGETHER AND MAKE ALL NECESSARY ADJUSTMENTS.
    • REMOVE AND REPLACE ENGINE CONTROL MODULE
    • PROGRAM ENGINE CONTROL MODULE
    • REMOVE AND REPLACE ALL IGNITION COILS
    • REMOVE AND REPLACE CENTER FUSE BOX WITH BCM
     
    JON P. gave our service a 5 star review on 8/22/2023